The B200 error common in your printer from Canon typically signifies your printer’s print head is dead! Before you throw away the printer or purchase an entirely new one, try one of these suggestions.
1. Take out all cartridges of ink and replace them with new ones.
2. Remove the print head and thoroughly clean the contacts made of gold within the printing head. When you reinstall the print head, ensure the connector for your ribbon cable is properly connected to the printer (this typically applies to earlier models).
3. After the print head has dried and been removed, thoroughly clean it by flushing the ink under the hot water faucet. This video can help you: Cleaning the print head
4. Another option to consider is to reload your printer drivers since a malfunctioning driver can cause an error message.
5. Try switching off the printer and disconnecting it from the wall for at most two hours. Sometimes this will work.
6. If nothing else works, please adhere to the steps in this instructional video.
7. Purchase a brand new Print Head from Canon and install it yourself. this is not advised as it’s usually cheaper to purchase a new canon pixma IP7200 Error Code b200.
The image on the left shows the process of cleaning the contacts of the head of the printer. They must be cleaned thoroughly using pure alcohol or clear fluid that is oil-based. If the contacts are dirty, they could cause the error code B200 to be triggered.
Cleaning the print head, you must be cautious as the head of print is extremely delicate and cannot withstand rough treatment. This photo shows the entire area of the printing head where the ink is sprayed. (between the thumb of his forefinger).
The next image to the left shows the proper method for cleaning the print head. Put it under an unheated water faucet and allow the water to flow through until it comes out clean.
This removes any hardened ink that has consolidated inside the print head.
The print head can be dried using a hair dryer or rubbed with a clean paper towel or cloth.Â
Read More Error code 5100 canon pixma mx432
How about replacing the printhead?
Many people are attracted to their printer, and even when it’s close to death, they don’t want to give it up. Many people aren’t technologically adept and have spent years figuring out how to operate the device. Then they master the art of printing only to be disappointed when the printhead issue occurs, which ruins them.
A lot of older people don’t think about how much it’ll cost to replace or repair the printer head, and even if they have to mortgage their home to them, it’s a better option rather than having to purchase an expensive new fandango printer, and then spend a few years learning how to operate it.
The best option is to update a brand new Canon printer since they’re similar to your existing printer. Installation is easy, and even though you might be hesitant when you leap, you’ll soon become familiar with how to operate this new model.
Removing the printhead is not even an option.
They’re expensive and difficult to locate; however, even if they repair the printer, a two-year-old or older printer will face another issue shortly. Most often, the drive gear will break the waste ink pad, the ink tank will become full, or another printer component may fail.
