“After updating the firmware of my Netgear Nighthawk router, the Remote Management option under the ‘Advanced’ section was not visible. Did I do something wrong that led me to this issue? Can you help me troubleshoot it?”
If you are also facing the Netgear remote management option not visible after updating the firmware by accessing the Netgear Genie setup wizard issue, then it is recommended that you walk through the troubleshooting hacks covered below in this article. They will surely assist you in handling this issue. Thus, get to reading.
Fix: Netgear Remote Management Option Not Visible Issue
-
Reboot Your Netgear Router
Technical glitches are one of the major contributing factors behind the Netgear remote management option not visible after firmware update issue. The only way to eliminate them is to reboot your Netgear router.
Rebooting your Netgear Nighthawk router requires you to turn it off, hold on for a couple of seconds, and then turn it back on. Simple to execute, isn’t it?
-
Check the Ethernet Connection
Another reason why you are struggling with the Netgear remote management option not visible after firmware update issue is because of a weak internet connection.
A weak internet connection is directly linked to the poor connection between your Netgear router and the existing modem. Therefore, ensure that the Ethernet cable connecting them is not damaged. If you have connected your devices wirelessly, then the distance between them should not be more than is required.
-
Eliminate WiFi Interference
Chances are that the room in which you are sitting with your laptop is filled with mirrors, fish tanks, cordless phones, washing machines, baby monitors, Bluetooth speakers, treadmills, televisions, refrigerators, microwave ovens, aluminium studs, etc.
Such things can interfere with the signals of your WiFi thereby stopping the signals from reaching your laptop and causing the Netgear remote management option not visible after firmware update issue. Thus, pick up your laptop and sit somewhere else.
-
Consider Refreshing the Page
Perhaps you are just stressing out for no apparent reason. What we mean to say is that there is a possibility you aren’t really facing the Netgear remote management option not visible after firmware update issue, you are just assuming that you are.
To confirm what we are saying, consider refreshing the page. Is the Remote Management option visible now? No? Looks like you are actually stuck with the issue.
-
Check the Downloaded Firmware
If you have downloaded a firmware version that is not compatible with the Netgear router model that you are using, then also you can experience the Netgear remote management option not visible after firmware update issue.
Therefore, update the firmware of your wireless device to its latest version again by accessing the Netgear Nighthawk setup wizard.
-
Reset Your Netgear Router
In case you are still getting bothered by the Netgear remote management option not visible after firmware update issue, then take our advice and perform factory default reset.
Restoring your wireless router to its default mode will surely help you rectify the issue at hand. Thus, here’s how you can reset your device:
-
Locate the Reset button on your router.
-
When found, press it.
-
Wait.
Now, use the Nighthawk router app and configure your Netgear router from scratch.
Wrapping Up
The Netgear remote management option not visible after firmware update issue is one of the topmost issues faced by users nowadays. We really hope that we were able to assist you to get rid of this issue with the help of the hacks mentioned above.
Did you like walking through this post? Yes? Well then, take some time out of your busy schedule and leave a word of appreciation in the comment section.